10" Rotor/Hub E-Coat Fits 5 X 4.5 wheel bolt pattern; 1/2" wheel bolts; 68111/44610 bearing cups
KODIAK 10" E-COAT Finish Vented Integral Rotor/Hub assembly, Caliper & Mounting Bracket w/Hardware. 3 YEAR KODIAK WARRANTY
E-coating offers the best value of protection for over the road use and for fresh water marine (or limited salt water) applications (i.e., during a standard salt spray test, rust will begin forming between 250 and 350 hours).
The INTEGRAL (One Piece) Hub & Rotor is cast as a single unit. Wheel studs are pressed into the rotor. Hub and rotor are balanced as one unit, which offers a smoother ride. Caliper mounts to 4 bolt brake flange and fits inside 13" and larger wheels. Caliper is loaded standard with Non-Asbestos Ceramic friction pads. Kit also includes inner bearing & race, outer bearing & race, grease seal. These Rotors/Hubs can be filled with the appropriate Grease or Hydraulic Oil. Refer to your installation manual before use.
Always use High-Temp. Marine Bearing Grease with disc brakes due to the higher operating temperatures as compared to drum brakes.
NOTE: KODIAK Oil Bath disc brakes will not work on axles with 'Super Lube' grease system spindles. However, you can use disc brake grease instead of oil for this product combination. Installation Manual Included with purchase (downloadable pdf file).
ROTOR DIAMETER: 10 inch. VENTED
REPLACES DRUM DIAMETER: 10 inch.
BEARING SIZE: 1-3/8" x 1-1/16"
GREASE / OIL SEAL ID: 1-11/16"
NUMBER OF STUDS: 5 at 1/2" diameter
BOLT CIRCLE: 4-1/2" (13" & Larger Wheels)
AXLE RATING: 3500 lbs.
CAN BE USED WITH ELECTRIC-OVER-HYDRAULIC ACTUATORS